next up previous contents
Next: Physical Model Up: FDC Project Previous: Why REDUCE   Contents

FDC Installation

After get the compressed FDC1.0.tar.gz file in directory /fdchome on you computer and where the fdchome is the directory in which you suppose the FDC1.0 will put in. Then 
   > cd /fdchome 
   > gzip -d  FDC1.0.tar.gz 
   > tar -fdc1.0.tar 
   > cd fdc1.0   
   > ls 
     src          ------ all the REDUCE source of FDC.
     bin          ------ excutable file of each part of FDC. 
     psdraw       ------ all the output will be put in. 
     idraw        ------ all the fortran source will be put in.
In the whole manual, we use "$>$" as the prompt of computer command, use ""GeV" is used for the Energy unit and decay width. "pbarn" is used for cross section.


wang jian xiong 2003-01-10